LAND ROVER NETS

Aug 25

Elite Land Rover Branch

These builds are based on 1/10th Scale 4x4 Land Rovers

BODY:

All bodies must be made of ABS Plastic, or 3D Printed bodies. All 3D printed bodies must be .060” thick.
All Bodies must be modeled after the Land Rover Company - ask if you don’t know.
All bodies must cover entire chassis
All bodies need a full windshield and full rear window
No Convertible tops allowed in this series. A full roll cage covering the entire interior is needed for this series
Half doors, tube doors are allowed. Tube doors must be at least 2 tubes 1”apart from bottom tube to top tube and must be secured shut like all doors.
No dovetailing
No Front fender pinching
Front/Rear Fenders must cover 80% of your tire.
Fender Flares allowed. Extreme fender flares will be disqualified.
Fender Flares must be used for the make they are made for, for example, no Jeep/Willy's shaped fenders for your D110 Truck so you can cut the wheel wells to that shape.
Approved 3D printed bodies only: Contact us for approval

INTERIOR:

Full 3D interior's are required - seats for all spots that would have a seat, floor board, dashboard, steering wheel, console/shifters, etc
Inner door skins are not needed, but will help in other ways.
The entire interior/cockpit must be constructed of plastic/ABS/Styrene
Molded interiors in bodies, like New Bright, must adhere to the scale guide lines but are accepted as 3D interiors.
Roll bar/headache bar is a must for open roof bodies. If using a cap, no need for a roll bar.
Scale Drivers must resemble a human figure.
All interiors must be deep enough for your scale drivers to be whole from the knees up.

FRONT BUMPER:

Front Bumper must be made of metal/aluminum
All bumpers must be attached to the chassis
You MUST have a scale winch on your front bumper, whether you use that, or a servo winch.
The servo winch line MUST go through the scale winch, if it’s static.
The front/face of the bumper must be a minimum 1” from the front of the body or a 2” minimum from the front/face of the front tire to the front/face of the bumper.
Front bumper must cover the entire front width of your body, excluding fender flares

REAR BUMPER:

Rear bumper must be made of metal/aluminum
All bumpers must be attached to the chassis
Rear bumper must cover the entire width of the rear of the body, excluding fender flares
The rear bumper must not be under the body.
You must have a trailer hitch. Attached to the chassis or rear bumper
The rear bumper must have at least 2 recovery points.

CHASSIS: Approved Only

SUSPENSION:

AXLES:

TIRES:

Max Tires size 4.19 - True Diameter - Measured The tire must not measure bigger than 4.19 regardless what the sidewall numbers say.
1.55/1.7/1.9 wheel size only
No Stretching tires over different wheel sizes.

LIGHTS:

RECOVERY:

SAFETY: