DIVISION TWO

Division 2 Rules:

To apply for this class your RC must meet these requirements to be eligible. Understand these rules may and can be changed without notice.

Division 2

The spirit of this Division is weekend warrior on the cusp of trailered machine. You've outgrown the smaller trails, and you're just not quite there for the big big trails, but you are close. You still have to drive it home. 

1/10th scale only BODY-

• Half-cab hardbodies are allowed

• Full body only lexan allowed and must replicate a 1:1 make and model

• Mandatory 3D interiors

• The bed can be bobbed and/or dove-tailed mildly.

• The truck bed must be as wide as the widest point of the cab. 

• Any truck bed must have a floor

• Bed of truck must cover length and width of the chassis

• Shocks can come through the floor of the bed

• Tires must be 50% covered by the body's fender wells and custom beds must cover the same amount

• Fender flares can be used for the style of your body being used

• No fender cut outs / Mild fender trimming ok to clear for steering. 

• All bodies need a windshield

• Front and Rear Bumpers must cover at least half of the front and rear of the body. Bumpers must be even or past the grill of the body. No under body bumpers allowed.

• All bumpers must be secured to the chassis only

• Molded into the body bumpers do not count

INTERIOR:

**interior must resemble the stock interior of the 1:1 make you are building**

• 3D interior's are required

• Molded interiors in bodies, like New Bright, must adhere to the scale guide lines but are accepted as 3D interiors.

• Roll bar/headache bar is a must for open roof bodies, ie Jeep, 4Runner, Blazer, Bronco, etc. If using a cap, no need for a roll bar.

• All interiors must be deep enough for your scale drivers to be whole from the knees up.

SUSPENSION:

• No shocks over 90mm

CHASSIS:

• Full chassis only

• No half chassis truggies

• Rear tube bed allowed with full chassis rails but must have a floor

TIRES:

• Max tire size - measured physical size must not exceed 4.55"

• Manufacturer tires only

• Some tread trimming allowed

• Sipping is allowed

• No cut, shut, comp tires allowed

 WHEELS:

• 1.55/1.7/1.9's only

• Wheel weights allowed

AXLES:

• Axles must be shaft driven

• No MOA's

• Axle width must be no longer than 9.5" from axle end to axle end

ELECTRONICS:

• All electronics and wires Must be hidden.

• Excluding wires for external use ie lights, winch

MISC:

• No rear steer

• No dig

• No servo’s on Axle’s allowed

Mandatory Items:

NA